Library Panel Beds

Library Panel Beds: Do-It-Yourself Kits

  • Available in twin, full, and queen size

  • Available in birch or oak

  • Complete kit, pre-cut and drilled

  • Solid plywood, no particle board

  • No cheap Chinese plywood

  • Low to no off-gassing of formaldehyde, low carbon footprint

  • Soft-close nitrogen gas springs

  • Rolling cabinet doors

  • Heavy duty solid steel metal parts (no hollow tubes)

  • No bolting to floor

  • No common carrier pallet shipping: First Class Fed-Ex shipping in our own boxes

  • High resale value

  • BEST IN ITS CLASS: 99% American Made

About Library Panel Beds

The library panel bed kits are made out of 3/4 inch cabinet grade birch or oak plywood, and edge banded with birch veneer. We use a steel continuous track on the base of the cabinet, and six steel rollers with ball bearings per sliding cabinet rated at 60 pounds each. If you anticipate heavy books in excess of 240 pounds we can add more rollers. The rolling shelves are locked in place so they won't come off the track. The metal frame is bolted to the cabinet base so only the cabinet is attached to the wall at the top.

This unit seconds as an entertainment center, gun cabinet or hidden doorway cover, or hide anything behind it.

High Quality, American-made

Our wallbeds are absolutely the very best do-it-yourself kits on the market today, and we've built and installed over two hundred of these beds. We make our standard bed cabinets out of cabinet-grade 3/4 inch birch, maple or oak plywood. Higher grades are available upon request and special orders can be made out of cherry or walnut. No finish is applied to the wood on these units, and if you intend to paint it we recommend ordering birch because it has a tighter grain. All exposed edges are edge banded with real wood and every exposed part is sanded smooth. All metal parts are coated with three coats of paint and black powder coating on all steel parts.The flip over leg is rated to hold 1000 pounds.

Assembly Information

All wood parts are numbered to match the packing list and pre-drilled. We provide a pictorial assembly and installation manual that is very comprehensive, plus you can call for personal attention if you are having difficulties. All wood parts are held together by square drive pocket screws and assembly is fairly easy if the instructions are followed in sequence.

Tools needed for assembly:

  • Six inch square drive #2

  • Rubber hammer

  • Flat Bar

  • #8 counter sink

  • Screw gun

  • Level

  • Hot glue gun

  • Framing square

  • Two 10 inch clamps. Nice but a helper would do, maybe.

  • Stud finder

  • Good attitude

  • Hammer

  • Bundle of carpenter shims

  • Screw drivers